Salam,
When I tried to install the 19.3 version it stopped at network configuration and didn’t continue. I was able to install by restarting, removing the Ethernet cable and skipping network configurations.
hope you could check this issue.
Thank you
Hello @uak. Welcome to our community;
It is normal for him to wait a little bit on the “configure network” page. So, were you able to connect to the internet after installation?
Hello Alperen. Thank you.
I’ve waited for almost 15 minutes but it didn’t move forward. I unplugged the network cable, restarted and continued new installation without a network connection.
So, were you able to connect to the internet after installation?
Yes, After removing the cable and rebooting.
I just wanted to report the issue so you may investigate it.
Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168/8411 PCI Express Gigabit Ethernet Controller (rev 09)
Seems like others have faced similar issues.
Bu konu son cevaptan 30 gün sonra otomatik olarak kapatıldı. Yeni cevap girilmesine izin verilmiyor.
